|
|
OCZ Vertex plus firmware 3.5
처런 
조회 :
1811 ,
2011/10/09 18:26 |
|
|
|
초고속 100Mb 다운 |
다운로드링크 복사
보드나라 자료실은 전용 고속회선으로 최대 100Mbps의 초고속 다운로드를 제공합니다
IE9 사용자는 다운로드가 응답하지 않을경우 도구-옵션-삭제 클릭하여 캐시 삭제후 클릭하세요
Updater for OCZ SSD
Firmware Version: 3.50
Affected SSD: Vertex-Plus
Updater Files: 60GB 760902.exe
120GB 760702.exe
Updater Setup and Procedures:
SETUP:
The System used to do the SSD Updater need to be configured for IDE mode. Setting SATA to AHCI mode will not work in DOS mode and may prevent SSD from being detected.
1. Reboot System and enter BIOS Setup.
2. In BIOS Setup, configure SATA to use IDE (mode). (This is to allow SSD to be able to be detected in DOS mode)
3. Configure Boot Priority with CD/DVD Drive being 1st device on the list.
4. Save the BIOS Setup and Exit.
5. Once SSD is updated, User could go back into BIOS Setup and revert configuration back to original settings.
Updater Procedures:
1. Download the OCZ Updater ISO file for the OCZ SSD drive.
2. Burn OCZ Updater ISO file to CD disk.
3. Insert CD disk into CD/DVD ROM drive.
4. Connect OCZ SSD to System (if Updating SSD not in current running System).
5. Boot/reboot System using OCZ Updater CD disk.
6. System should boot to DOS mode.
7. Select the Option number corresponding to SSD Drive (SSD Drive needing the Update).
8. When requested to search for SSD Drive, Enter "Y". Found drive should be displayed, Enter the Option number corresponding to the drive.
9. Updater should program the drive successfully and dispay completion message.
10. User should be returned to main menu.
11. Repeat steps 7-10 if doing multiple SSD Drive.
12. After all SSD Drive have been Updated, Exit program to go into DOS Prompt. Remove CD from CD/DVD ROM Drive and reboot System.
|
|
|
|
